mute or play
Hi,
I am busy with a 4 staff piece of music. I can mute or play staffs 2, 3 and 4 but staff 1 is dead, dumb and without sound. I have looked all over and tried the help information but I cannot get staff 1 to play. Any advice? |
Re: mute or play
Hi,
A few things to look for: 1. The MIDI playback device - in Staff/Setup, check the Device and make sure it is a device that is "on" for your setup. Also check the Bank, which typically should be "000,000 General MIDI" unless you have a special setup. 2. Volume - make sure the volume level of the staff is set around the same value or higher as the other staves. You can check this in the Staff/Settings. 3. Note velocity - use the Note Velocity tab (if you're using Notation Composer) to see the Note velocities - just mouse-over the notes. If they are low (eg. 40 or lower), you can (1) click the Staff Select button (2) use Region/Convert Region to a selection of notes and (3) hold the L key (for "loudness") and press the Up arrow key to make the notes louder. If the above suggestions don't help, please either post a copy of the file, or send me a copy at support@notation.com and I will take a look at it. ttfn, Sherry |
Re: mute or play
Thanks Sherry,
It was indeed nr 2 - the staff volume that was giving me headaches. Phlip |
All times are GMT. The time now is 03:46 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Notation Software Germany GmbH www.notation.com/Imprint.php