|
||
| |
||
|
|||||||
| Questions or problems Have a question or problem about something you can't find in the Help/Users Guide? Ask it here! |
 |
|
|
Thread Tools | Display Modes |
|
#2
12-07-2010, 12:52 AM
|
||||
|
||||
Re: Deleting or Clearing measures
Howdy,
You can use the "Undo" command immediately following (or some number of operations out if needed) or you can use Measure/Insert to later add the measure back in. ttfn, Sherry
__________________
Music is to the soul like water is to green growing things. 
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Add Measures Problem | IanMc | Questions or problems | 6 | 10-09-2009 01:04 PM |
| Fixed number of measures per staff on a part | Jonathon Bell (jonathonbell) | Tips and tricks for using Notation Software products | 1 | 02-13-2007 03:31 AM |
Linear Mode
