|
|
Questions or problems Have a question or problem about something you can't find in the Help/Users Guide? Ask it here! |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Volume change of Selected Staves.
I want to change the volume of a selected stave line relative to the others in a piece of music down loaded by Musician.
I choose Staff controls from the view command, click the little blue arrow only in Staff Selection and while the music is playing move the Volume slider. This however changers the volume of all the staves not the specific one highlighted. This is as written in instructions, but is not working. What am I doing wrong? Thanks. |
#2
|
|||
|
|||
Re: Volume change of Selected Staves.
Hi, Impulse:
To permanently change the volume of one or more staves, you can use the Staff Setup to enter an initial numeric value for each staff. Alternatively, for changes within the music, you can click on the GraphOverNotes(TM) tab, make sure the VOL icon is selected and use the tools in the toolbar to draw volume lines or curves or erase data. The "96" icon will let you input a numeric value for a range you've previously selected. The volume slider and temp scroller are intended for temporary changes, for example, when working on a piece and wanting to try out an effect without any permanent changes. I've frankly never even looked at the volume slider before (in, what?, 15 years of using Notation Software), so I'm not sure of what it's supposed to do. I'll do some checking on it and see what's happening. But, to change volume on a more permanent basis, use the Staff Setup or GraphOverNotes(TM) methods. David |
#3
|
||||
|
||||
Re: Volume change of Selected Staves.
Hi,
Quote:
We decided against actually increasing any volumes higher than the "set" volume so as to avoid blowing out ears or speakers ttfn, Sherry
__________________
Music is to the soul like water is to green growing things. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Overview of Volume, Pan and Note Velocity (editing in Notation Composer) | Sherry C | Tips and tricks for using Notation Software products | 0 | 10-08-2012 01:05 PM |
Unexplained volume change | Tim Mariott | Questions or problems | 3 | 02-01-2012 01:10 PM |
Using Note Velocity and Volume to get good performance balance in Composer | Sherry C | Tips and tricks for using Notation Software products | 0 | 02-26-2010 04:23 PM |
Volume Expressions/Dynamics | jcardana | Suggestions and feature requests | 1 | 10-26-2009 12:13 AM |
increase main volume level at play start | TheDutchjewel | Questions or problems | 10 | 10-05-2009 06:47 AM |