Measure Numbers for Repeat Staff Endings

[Sherry C]

Hi Iain,

Originally Posted by IanMc

I have a tune which in part A has 1. & 2. repeat endings. NC gives each of these a separate measure number. In several of the sheet music books I have, this does not happen - each is just considered to be a different rendition of the same measure, and therefore given the same measure number.

I have included the .not file as well as a jpeg of the tune from my book.

Since Composer also performs the measures (rather than just drawing them to look nice), it needs some way of telling those measure 9s apart, and sequential numbering is just easiest for Composer and for the user that may want to manipulate the repetition instructions. I have seen measure numbering like you're showing here. But I've also seen published measure numbering in sequential numbers (like Composer currently does.) I'll consult my notation standards guru

Originally Posted by IanMc

Following up on the above, I now cannot change the numbers of bars per line in the Layout section. I keep getting a red message in the bottom RH corner "Command is unexpectedly complex". This happens even if I try to reset the layout back to default (Def). Tried closing the file and restarting the program, even rebooting but still the same message.

I've confirmed the same problem on opening your attached file here. Was there a point previously where you could use the Layout/Page Layout/Specify number of bars per system? If so, you may have a copy of that file in your Autosave archive. It would be really helpful (ie save me lots of time ) if you do have such a copy that allows you to use the Specify command. Then I can compare them to hopefully figure out the problem.

Thanks!
Sherry

This is the error message:
LayoutFixedNumberMeasureError.png